Accessories
KITK30
Fitting kit to be used with K30/140 and MTC3008.
KITK52175
Fitting kit to be used with K30/140 and MTC5210-MTC17510.
K30/140B
If dual station steering is required, then it is necessary to install this block, or to use two steering pumps with built in non-return valves (type HTPR).
HTPF3
HTPF3 can be used for situations where the HTPF or HS1000 wheel adjuster may fill with water. Consists of a rubber seal and a stainless steel trim ring.
HTPF2
This polished stainless steel flange can be used to fit a pump type HTP to replace an older type MTP pump. It can also be used as a simple embellishment.
HTPF
This polished stainless steel flange can be used to fit a pump type HTP to replace an older type MTP pump. It can also be used as a simple embellishment.
HTANK
This transparent tank with vented screw cap can be installed with all VETUS steering pumps up to 89 cm³ per revolution. Supplied with mounting bracket.
HS145S
Set of 20 pieces. Push in support sleeve for HHOSE6 6 x 10 mm hose and 10 mm compression fittings found on HPT3010/4010 Helm Pumps/MTC52 -MTC175 cylinders.
HS1037MS
Set of 2 pieces. Heavy duty, reusable screw on fitting for use with 8 x 12 mm hose. Right angle connector with 10 mm tube section for compression fittings.
HS1031MS
Set of 2 pieces. Heavy duty, reusable screw on fitting for use with 8 x 12 mm hose. Straight connector with 10 mm tube section for compression fittings.
HS10131
Set of 10 pieces. Push in support sleeve and olive set for HS04N 6 x 8 mm hose and 8 mm compression fittings found on HPT..08 Helm Pump/MTC3008 Cylinder.
HS1011S
Set of 20 pieces. Push in support sleeve for use with HS04N 6 x 8 mm hose and 8 mm compression fittings found on HPT..08 Helm Pump and MTC3008 Cylinder.
BYPASS8
If a change-over to tiller steering is required an installation of a by-pass valve is necessary.
BYPASS10
By-pass valve for Ø 10 mm tubing (incl. tube connectors Ø 10 mm.)
COPPER18
Suitable for VETUS hydraulic steering systems.
COPPER10
Suitable for VETUS hydraulic steering systems.